I have an existing panoramic and wish the slideshow to pan across the photo from left to right.

rickatindy1962 wrote on 11/3/2012, 3:35 PM

I have an existing panoramic and wish the slideshow to pan across the photo from left to right. I can do that with "create panorama" but the pano is already complete. I am using PhotoStory 2013 Deluxe. The Pano was created with Kolor AutoPano Giga 2.6.

Comments

nancyandbob wrote on 11/14/2012, 10:35 PM

With the picture already in the slideshow,

Click instructions below mean left single click.
Select it by clicking on it (it should hilight).
Click on the FXEffects tab at the top right section
Click View and Animation to expand that menu section
Click Camera/zoom and Edit. (The word Edit should change to Preview.)
Click the Red X to the right and down from Camera/zoom. That will remove any special formatting on this slide.
The rest of the instructions assume panning left-to-right
Under Duration, select Over full duration.
Adjust the frame to the height of your panorama and position it to the far left.
In the section Movement in Direction, click once on the arrow pointing to the right (seems backwards to me).
Click Preview to finish the process.

You should be able to test the results with the control buttons under the preview pane now.

There's really quite a bit you can do with the Camera/zoom control. It just takes some persistence to figure how to use it. I've got a ways to go.

Good Luck!