My m-audio delta 66 software is showing input but music studio 2013 and 2014 is only picking up 3-4, nothing from 1-2 from the m-audio delta 66.

bkroberts88 wrote on 1/19/2016, 3:56 PM

I have been using this setup for 5 years and out of nowhere my software is not picking up 1-2 inputs from m-audio delta 66. Delta 66 is PCI connected break out box, has 4 inputs and 4 outputs, working fine until last month and the m-audio driver shows input coming in from 1-2, just doesn't carry over to music studio 2013 and 2014. The only change to PC was upgrade to Windows 10, I can get 3-4 into software but not 1-2.

Comments

johnebaker wrote on 1/20/2016, 12:04 PM

. . . . The only change to PC was upgrade to Windows 10 . . . .

Check that the M-Audio drivers have not been replaced by Windows 10 divers - you need 32 bit drivers installed.

If that fails try re-installing the software following this procedure - remove both versions of SMS in step 1 - 2014 first then 2013 , then clean out both versions folders in step 2.

When re-installing install 2013 first and add all the extra free downloads, then install 2014 and the extras.

HTH

John EB

bkroberts88 wrote on 2/3/2016, 6:29 PM

Thanks!!!! That worked, had to step back one version of driver. Thanks again, happen to know of any work arounds for getting M-Audio Quattro to work on Windows 10? Found one online cheap, thought I could find something, no luck.

johnebaker wrote on 2/4/2016, 3:13 AM

. . . . any work arounds for getting M-Audio Quattro to work on Windows 10 .. . .

It is unlikely you will be able to get compatible drivers for this device - it was discontinued around 2011/12.

The latest drivers available are for Windows Vista which are likely to be incompatible.

John EB