Comments

asoeli wrote on 1/23/2012, 2:27 AM

When going to "Burning", there came a question if there were no chapter markers: "Only one marker" and "Automatic marker". If you clicked the "Automatic", you'll get a chapter marker at each clip.

starship.1 wrote on 1/27/2017, 5:06 AM

Hi. I know this is an old post, Just reopening this as  I am in a similar situation. I made the mistake in clicking "Only one marker" , I then  saved the project. Now each time I open the project and burn, I have no chapters which is understandable.. Can I edit this to "Automatic Marker".

I am using MEP 2015 plus. Thanks

terrypin wrote on 1/27/2017, 6:57 AM

Hi,

Sure. First just delete all the chapter markers, using Edit > Markers > Delete all chapter markers.

Then, when you switch to Burn mode, which will prompt you about the absence of markers, choose the Automatic option.

 

starship.1 wrote on 1/27/2017, 7:19 AM

Thank you Terry for your prompt reply. I have checked that out, but the "Delete all Chapter Markers"  is not high lighted, unable to click on it... regards.

starship.1 wrote on 1/27/2017, 10:42 AM

Update., I found that if you right click on the marker shown in the timeline and delete it, Go to Edit- Makers- Delete All Markers, it appears and can be edited  when prompted the Automatic option. Job done.. Thanks.